Aluminum Machining for Albuquerque, NM
If you are asking where to get aluminum machined near Albuquerque, Wexmar is a full CNC shop in Canastota, NY that machines 6061, 7075, 2024, 5052, and MIC-6 for Albuquerque manufacturers in semiconductors, defense research systems, and aerospace and ships finished parts to Albuquerque on served on a two-to-three-day LTL freight lane out of Central New York.
Aluminum parts we machine for Albuquerque
Housings, enclosures, heat sinks, brackets, manifolds, plates, fixtures, spacers, standoffs, shafts, and fittings. Horizontal machining centers with pallet changers make multi-face aluminum housings efficient at any quantity.
Alloys and tempers
6061-T6 for general parts, 7075-T6 for strength, 2024-T3 for aerospace hardware, 5052 for corrosion service, and MIC-6 cast plate for flat, stable fixture and instrument bases.
Finishes for aluminum
Type II and Type III hard anodize, chem film (Alodine), and powder coat are handled through qualified outside processors and quoted with the machining. As-machined and bead-blast finishes are done in house.
Fast, documented aluminum work
Aluminum cuts fast, so lead times are short. CMM reports, first-article inspection, and material certs ship with Albuquerque orders on request.
Albuquerque at a glance
- Service
- Aluminum machining
- Alloys
- 6061, 7075, 2024, 5052, MIC-6
- Finishes
- Anodize, chem film, powder coat via partners
- Machined in
- Canastota, NY
- Ships to
- Albuquerque, NM
- Transit
- served on a two-to-three-day LTL freight lane out of Central New York
Aluminum Machining for Albuquerque, NM: FAQ
Where can I have aluminum machined near Albuquerque?
Wexmar machines aluminum in Canastota, NY and ships to Albuquerque. Upload a PDF or STEP for an instant estimate, and a human estimator confirms pricing and freight.
Do you anodize aluminum parts?
Yes, through qualified outside processors. Type II, Type III hard coat, and chem film are quoted with the machining and managed by Wexmar.
What tolerances do you hold on aluminum?
Plus or minus .005 in is typical on general features, with plus or minus .0005 in on fits and bores where the print requires it, verified on CMM.