Inconel and High-Nickel Alloy Machining for Lansing, MI

High-nickel alloys punish the wrong setup. Wexmar machines Inconel 625 and 718, Monel 400 and K-500, Hastelloy C-276, and Nitronic 50 for Lansing manufacturers in automotive assembly and precision auto components with rigid fixturing, slow surface speeds, and sharp tooling, then ships inspected parts to Lansing on one-to-two days by LTL freight from Central New York.

Machining Inconel for Lansing buyers

Low SFM, high-positive carbide or ceramic inserts, consistent chip load, and no dwell keep work hardening under control. Turning and horizontal milling handle fittings, flanges, shafts, and housings; Swiss handles small-diameter pins and fittings.

Alloys we run

Inconel 625 and 718, Monel 400 and K-500, Hastelloy C-276, Nitronic 50, and other nickel and cobalt alloys on request. DFARS 252.225-7009 specialty-metals-compliant sourcing is available.

Where these parts go

Oil and gas, power generation, aerospace, chemical processing, and defense hardware where heat and corrosion rule out stainless.

Documentation and inspection

Material certs with heat-lot traceability, CMM dimensional reports, and first-article inspection are quoted as line items and ship with the parts to Lansing.

Inconel and High-Nickel Alloy Machining for Lansing, MI: FAQ

Why does Inconel machining cost more for Lansing orders?

Nickel alloys run at a fraction of the surface speed of steel, wear tooling quickly, and cost more per pound, so both cycle time and material are higher. The instant estimator gives a range from your drawing.

Can you machine Inconel 718 in the aged condition?

Yes, with slower speeds and rigid setups. Many buyers prefer machining in the solution-annealed condition with aging through an outside processor afterward; we quote both.

Do you provide DFARS-compliant Inconel?

Yes. DFARS 252.225-7009 specialty-metals-compliant sourcing is available, with mill certs and heat-lot traceability.